448, 448ME Vernier Depth Gages 0-12"/0-300MM Theseareeasy-to-use,veryaccuratedepthgages.Theyaredesignedformeasuring the depths of holes,slots,and recesses and for inspecting jig,fixtures and die work. They are also ideal for measuring from a plane surface to toolmakers' buttons for locating center distances. Readings are in .001" and 0.02mm. • Heads are hardened, ground and lapped • Measuring blades are hardened and ground and have accurate and sharp machine divided graduations • All English graduations read to .001", with the bar being graduated in .025" increments • All metric graduations read to 0.02mm, with the bar being graduated in 0.5mm increments • Screw type adjusting nut allows for fine measuring adjustment • Slide lock nut to hold measurement position • Vernier plates are adjustable 237 , 237M Steel Rule Depth Gages 0-6"/0-150MM These very handy depth gages can be used to quickly obtain measurements in 64th of an inch or 1/2mm by simply adjusting the rule to the required depth. • The gage consists of a nicely finished,hardened steel head and an accurate, machine divided, tempered steel rule. These rules are either our 610N (6") or our 635N (150mm) models. • Gage can be smoothly adjusted to the required measurement and then locked into position by a knurled nut • Base is cut out on one side, adjacent to the rule, permitting easier readings and more accurate measurements • 6" hook rule (236HC, EDP 51077) also available, permitting easier readings from the edge of a workpiece to the edges of slots, shoulders, etc. Graduated in 32nds, 64ths. Depth Gages 237 448MEZ-6 Inch Reading/Graduation – .001" Cat. No. EDP Range Blades Furnished Base Length x Width 448Z-6 52306 0-6" One (6") 2-3/4 x 1/4" 448Z-12 52308 0-12" One (12") 448Z-612 52310 0-12" Two (6" and 12") Inch and Millimeter Reading/Graduation – .001" and 0.02mm – Both Edges Cat. No. EDP Range Blades Furnished Base Length x Width 448MEZ-6 52312 0-6" (150mm) One (6"/150mm) 2-3/4 x 1/4" (70 x 6.35mm) 448MEZ-12 52314 0-12" (300mm) One (12"/300mm) 448MEZ-612 52316 0-12" (300mm) Two (6"/150mm and 12"/300mm) 237 Steel Rule Depth Gages (0-6" Range) Cat. No. EDP Graduation Head Length x Width 237 51080 32nds, 64ths 2-5/8 x 1/8" 237M Steel Rule Depth Gages (0-150mm Range) Cat. No. EDP Graduation Head Length x Width 237M 51081 mm, 1/2mm 66 x 3mm 128 D epth G ages