/  Metrology Equipment  /  Laser Measurement Systems  /  

Tire Industry Products

  /  

Off-Line Profilometer

 /

OFLP-600-30

Off-Line Profilometer #(--edpnumber)#

Tire Industry Products
Off-Line Profilometer

The Starrett-Bytewise Profilometer was developed as an automated, non-contact measurement system to displace checking with hand tools. The Profilometer is used to verify the accuracy of newly-cut dies by checking the extrusion dimensions. Its accuracy and speed helps reduce the number of die trials needed to approve a new die for production. Once in production, the Profilometer is used to check each run for overall quality, and to monitor for die wear. The Starrett-Bytewise Profilometer can help you improve your extrusion quality, reduce raw materials cost, and reduce extruder down-time for die trials.

Features
Specifications
Product Testimonials
Contact Starrett

Features

  • The Laser Sensor feature is optimized for accurate measurements on black rubber
  • The Thermal Protection feature turns sensors off at 45 degrees Celcius
  • The Servo-motor linear axis provides accurate and repeatable scan control
  • The Dual Axis Option permits averaging for up to three side-by-side scans
  • The Import Specifications feature imports XY break points from a data table
  • The Gauge Report lists the measured thickness values at each breakpoint along with the design specification and error amount
  • The Point Report lists the measured width values at each breakpoint along with the design specification and error amount
  • The Symmetry Report compares the right and left side point width, thickness, region area, and center of gravity
  • The Regional Report analyzes the area and center of gravity
  • The Conicity Report compares the area distribution of one side of the extruded component to the other side
  • The Graphical Overlay compares multiple runs
  • The INI file is used for configuration for testing and reporting schemes
  • The Optimized Calibration feature measures 16 thickness values and 4 angle values to assure accuracy across the entire range
  • The PC Controller allows easy replacement of a standard HP desktop PC from a local source
  • The IPC Option allows the customization of an Industrial PC per the customer's specifications
  • The Remote Support feature enables software updates and training via the Internet via a secure link

Specifications

  • Made in America: Yes
  • Width Range: 600 mm or 1000 mm
  • Thickness Range: 30 mm or 60 mm
  • Width Accuracy: 0.0125 mm
  • Width Repeatability (1s): 0.0125 mm
  • Thickness Accuracy: 0.0125 mm or 0.0250 mm
  • Thickness Repeatability (1s): 0.0125 mm or 0.0250 mm
  • Thickness Resolution: 0.00875 mm or 0.0175 mm
  • Area Accuracy: 0.025%
  • Area Repeatability (1s): 0.025%
  • Laser Spot Diameter, Top: 0.1 mm or 0.3 mm
  • Laser Spot Diameter, Bottom: 0.1 mm
  • Width Point Spacing: 0.1 mm
  • Dual Axis Range: 20 mm
  • Cycle Time: 30 sec or 50 sec
  • Laser Frequency: 16 kHz
  • Laser Resolution: 0.008 mm
  • Current at 230V: 10 A
  • Laser Classification, CDRH: IIIb
  • Laser Classification, IEC: 3b
  • Low Voltage Directive: Yes
  • EMC Directive: Yes
  • Machinery Directive: Yes

Product Testimonials

    Write a product review